How Do I Install the Sear and Trigger Assembly?

WARNING!!!

When installing the sear on your youth or adult trigger please take note on the correct positioning.

The sear must be installed correctly to be safe. Check the position when you remove and replace to eliminate any chance of failure.

Included below are images of the youth and adult trigger showing the correct position of the installed sear.

CORRECT Sear Installation on Trigger

CORRECT Sear Installation on Trigger

 

How Do I Install My Crickett®/Chipmunk® Pistol Scope Mount?

Installation Instructions:

  1. Remove the two 6×48 plug screws on the front of the receiver and the entire rear sight assembly.
  2. Place the mount base in position and start the three 6×48 screws. Do not tighten.
  3. With one hand, clamp the mount base onto the receiver. Tighten all three screws, one turn, each at a time until tight.
  4. Install and tighten any standard tip-off rings and scope of your choice.

How Do I Install My Crickett®/Chipmunk® Rifle Scope Mount?

Installation Instructions:

  1. Remove the two 6×48 plug screws on the front of the receiver and remove the 6×32 screw holding the rear peep sight from the rear sight elevation bar.
  2. Loosen the rear sight elevation screw (on side of the receiver.)
  3. Place mount base in position and start the two front 6×48 screws and one rear 6×32 screw.
  4. Continue to fully tighten the front two screws. Then tighten the one rear screw.
  5. Maintain down pressure on mount and tighten the elevation screw.
  6. Install and tighten any standard 3/8″ tip-off rings and scope of your choice.